About
Cleaning and coating process video:
ADVANTAGES
High Performance
High performance and ability to apply thick coating layer
Low Porosity Of The Coating
Substantially lower coating porosity (less than 1% vs. 15-30%).
High Adhesion Coating
Significantly higher adhesion of the coating (many times higher, many tens versus just a few megapascals)
Safe & Easy
Complete safety and ease of use of PRANS HSS X7 and X8 equipment
Quality of Treatment SA 3+
The quality of surface treatment is guaranteed at the level SA 3 and higher (a potential of 0.7-0.8 V is formed on the surface) without any kind of contamination and oxide films
Low Abrasives Consumption
Consumption of any abrasive required for high-quality surface preparation is several times less.
Two Processes.
One Unit
The PRANS HSS X8 unit is designed for thermo-abrasive cleaning of surfaces and structures made of various materials from any coating, oxide films, limescale, fuel oil deposits and other contaminants with subsequent application of a protective zinc coating onto the cleaned metal parts.
Switching between cleaning and coating processes with no delay.
Switching process video:
![](https://hansasupersonic.com/wp-content/uploads/2018/12/isct-1024x188.png)
Before & After Samples
![](https://hansasupersonic.com/wp-content/uploads/2019/02/MG_0920.jpg)
![](https://hansasupersonic.com/wp-content/uploads/2019/02/MG_0921-1.jpg)
![](https://hansasupersonic.com/wp-content/uploads/2019/01/ok.jpg)
![](https://hansasupersonic.com/wp-content/uploads/2018/12/sergeizjuganov_IMG_7875small.jpg)
![](https://hansasupersonic.com/wp-content/uploads/2019/02/MG_0916.jpg)
![](https://hansasupersonic.com/wp-content/uploads/2019/02/MG_0931.jpg)
Technical Specs
220 V, 50 Hz
0.7–0.8 MPa
4.5–6.5 m3/min
2-3 hours
8.0–15.0 l/h
from -5°C to +30°C
20-40 m2/hour
1.0 mm
6–15 kg/m2